1 kg = 110.40 €
-Multi-peak technology: With its advanced "multi-peak" technology it is possible to track mppt even when shadows affect solar panels causing rapid I-V peaks in production. Its mppt load algorithm significantly increases the efficient use of energy in solar systems and achieves improvements of between 20 and 30% in load efficiency compared to PWM technology. The combination of multiple tracking algorithms allows optimum mapping Of the working point of curve IV in an extremely short time.
-Connection in series of panels: Supports up to 100 volts of input which allows to use panels of 60 and 72 cells in series of 2 panels. 12 and 24v operation allowing 24 volt panels to be used in 12 volt systems
-Fully configurable: They allow the use of any type of lead acid battery, gel or agm. User mode to customize load parameters. Voltages, charging times, auto-equalization intervals can be modified ... also allows the use of lithium batteries (see). Supports maximum 17v equalization voltages in systems at 12v and up to 34v in 24v systems
-Register of Histories: The equipment stores up to five years of system registrations including minimum voltage, maximum voltage, charged kilowatts, maximum charge current ...
-Protections: The equipment has lightning protection via TVS diodes. It also has protection against overtemperature reducing the load current if they reach more than 65 degrees without damaging the equipment but between more power than allowed. Protection against inverted polarity and short circuit. IP 32 protection against dusty environments and splashing water
Error codes: By means of the error codes screen we can easily see when there is an anomaly and identify which is the cause. Connection with inverted polarity, photovoltaic field overvoltage, overload ... all have an error code duly identified in the manual
Programmable consumption output: The "load" output of 20 amps allows the use of consumptions directly connected to the equipment that operate to the battery voltage (illumination to 12v or 24v, pumps ...) in this controller also allows the Use of capacitive loads such as small pumps because the output allows starting peaks The output can be programmed for lighting or street lamps with an automatic mode of activation from the twilight
-Software: By means of the data cable and the software we can connect the equipment to a PC and monitor, configure voltages, configure load times, access the historical register, etc. Allows communication by modbus