Power Centre. SW 01 Dolls House Lighting 1:12TH or 1:24
A very easy way to connect your house lights to the power supply. with out white plugs
1. Mount on the Dolls’ House using the 4 holes pre-drilled in the unit. Use the spacers supplied with each unit and suitable screws.
2. Connect Power 12V +/- plug into 2.1mm centre-positive dc power connector. 3. Connect a maximum of 85 bulbs to terminals marked 1-10 +/- by baring the wire ends, inserting into desired +/- terminal openings and tightening screws (only enough to ensure a good contact).
4. Optionally connect an external unit (e.g.Flicker unit), or additional Easy Wire Power Controllers, using terminal block marked +/-,adjacent to the power socket.Max 3 more information contact us
5. Calculate the correct fuse for the total load on “Power Controller”. Each 1 amp of current can power around 14 bulbs.Calculate the total bulb loading, divide this by 14, then round the answer up to the next
whole number. This is the size of fuse required. Max. allowable fuse = 5 Amps.The correct fuses are 20mm x 5mm glass fuses, slow-blow characteristic. These are available direct from SWP, or from your
local TV / Radio repair shop. The unit is fitted with a 1 Amp (14 bulb) fuse as standard.
6. Switch the power on. Green lamp should light. If not, check 12V power is OK, fuse is OK and +/- connection is correct polarity.
7. The Dolls House Power wiring is now finished!
Max 3 more information contact us
Fuses sizes Grain wheat Screw-in-Bulbs
1 Amp 20 14
2 Amps 40 28
3 Amps 60 42
4 Amps 80 56
5 Amps 100 70